Hydraulic cylinders and components, hydraulic systems, gas springs & shell and tube heat exchangers : Quiri

Home » Quiri Hydromécanique » Hydraulic Clamping Systems » Swing clamps with position detection » Swing clamp with planar rotation – 160 bar – Pneumatic sensing of released and clamped position PL**XB12

Swing clamp with planar rotation – 160 bar – Pneumatic sensing of released and clamped position PL**XB12

Double-acting - planar rotation - pneumatic sensing of clamped and released position Force at 160 bar: 10 kN

Supply through counter-bores under the flange ring

Swing clamp with planar rotation – 160 bar – Pneumatic sensing of released and clamped position PL**XB12 : Swing clamps with position detection - Quiri

Characteristics

• detection of clamped and released position by adjustable
• leak-free valves
• left or right planar rotation, 90°±2°
• bleeders on clamping and release side
• rod indexing
• max. pressure: 160 bar

Options

• clamping arm: see accessories section
• 60°, 45° or 0° rotation on request

Nota

The clamps are supplied with O-rings, lock nut and lock washer (dimensions: see Lock washer for clamp type P11, P21 and Nut for clamp type P31 and P41)
O-rings: 7.65 x 1.78 90 NBR

Print this sheet

Definition of forces depending on clamping arm: consult the guide
Important recommendations: consult the guide

F max at 160 bar	Rod ød	Travel	Max flow rate A	Swept volume A B	Direction of rotation	Type	Reference
F max at 160 bar	Rod ød	Travel	Max flow rate A	Swept volume A B	Direction of rotation	Type	Reference	a	c	øD	e	f span-ner	h	øk1 øk2	L	L1	L2	L3	m	p1	p2	p3
kN	mm	mm	l/min	cm³				mm	mm	mm		mm	mm	mm	mm	mm	mm	mm	mm	mm	mm	mm
10	36	12	2	41	right	PL 31 DX B12	192 142/050	18	20	80	M24 x 1.5	10	41	110	301.5	248.5	220.5	43	29	8.5	14	11
10	36	12	2	53	left	PL 31 GX B12	192 142/150	18	20	80	M24 x 1.5	10	41	95	301.5	248.5	220.5	43	29	8.5	14	11

View similar products

Swing clamp with planar rotation – 160 bar – Hydraulic sensing of clamped position PL21XH

Double-action - planar rotation - electrical position check
Force at 160 bar: 5 kN

Swing cable with helical rotation – 250 bar – Pneumatic sensing of released position HL**XB1

Double-acting - with helical rotation - pneumatic position sensing
Force at 250 bar: 7.5 to 36.5 kN

Swing clamp with planar rotation – 160 bar – Electrical sensing of released position PL**XE

Double-acting - planar rotation - electrical sensing
Force at 160 bar: 10 kN

Swing clamp with planar rotation – 160 bar – With sensing rod PL**XA

Double-acting - planar rotation - with sensing rod
Force at 160 bar: 10 and 15 kN

Back to Swing clamps with position detection Back to top